Teseq NFPS 1 Near Field Probe Set 9 kHz – 1 GHz
Description
Teseq NFPS 1 Near Field Probe Set 9 kHz – 1 GHz is a diagnostic “tool kit” for use in both electrical and mechanical environments featuring three hand held probes (two magnetic, one electric) together with a 30-dB pre-amplifier, power adaptor and check jig. When used in conjunction with a spectrum analyzer or measuring receiver, the probes will readily locate and qualify sources of EMI (electromagnetic interference).
Features
- Locate emission “hot-spots”
- Check on mechanical screening performance
- Isolate faulty components
01
02 Download Data Sheet
Print
Email
Specifications
| MFP 9150 Magnetic Field Probe | |
| Specified frequency range | 9kHz – 30MHz |
| Connector | 50Ω SMA Female |
| Max. RF power input | 0.5 Watt |
| Size (Incl. RF connector) | 256 x 38 x 18mm |
| Operating temperature | 0 – 45°C |
| MFP 9151 Magnetic Field Probe | |
| Specified frequency range | 30MHz – 1GHz |
| Connector | 50Ω SMA Female |
| Max. RF power input | 0.25 Watt |
| Size (Incl. RF connector) | 256 x 38 x 18mm |
| Size (Incl. RF connector) | x 0 – 45°C |
| EFP 9152 Electric Field Probe | |
| Frequency range (±3dB) | 9kHz – 1GHz |
| Antenna factor | 67dB[(mV/m) /mV] |
| Connector | SMA Female |
| Size (Incl. RF connector) | 267 x 38 x 18mm |
| PCJ 9251 Check Jig | |
| Connector | N (Male) |
| Connector | Ix 50Ω |
| Max. RF power input | +20dBm |
| CPA 9231A Pre-amplifier | |
| Frequency range | 9kHz – 2GHz |
| Noise figure | ≤ 4dB |
| Input connector | N (Female) |
| Output connector | N (Male) |
| Gain | 30dB ± 2dB at 1GHz
18dB at 2GHz |
| Input/ output impedance | 50Ω |
| Input VSWR | < 2:1 |
| Power requirements | 15V ± 10% DC or |
| With probe) | (10V ± 0.1V DC at 100mA |
| CPS 9752 Power Adaptor | |
| Power requirements | 15V ± 1.5V dc |
| (With probe) | or 10V ± 0.1V dc |
| RF input connector | BNC (Female) |
| RF output connector | N (Male) |
| Size (Incl. RF connectors) | 103 x 26 x 27mm |
