Amplifier Research 10S4G11A Solid State Amplifier 4GHz – 10.6GHz 10W

Description

Amplifier Research 10S4G11A is a solid state, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth and high gain are required. Housed in a stylish contemporary cabinet, the unit is designed for benchtop use, but can be removed from the cabinet for immediate equipment rack mounting.

The 10S4G11A, when used with a sweep generator, will provide a minimum of 10 watts of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level.

The 10S4G11A is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over temperature by removing the DC voltage to them if an over temperature condition occurs due to cooling blockage or fan failure. There is a digital display on the front panel to indicate the operate status and fault conditions when an overtemperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared.

The 10S4G11A includes digital control for both local and remote control of the amplifier. The control system is composed of a 16-bit RISC microcontroller board which handles primary functions of the amplifier and interprets commands sent to it from an 8-bit remote interface board. This 8-bit microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions.

 

Features

  • Solid State Broadband
  • Mismatch Tolerant
  • Modulation Capability
  • Digital Control Panel
  • Automatic Primary Power Selection
  • RF Input Leveling Circuit – Overdrive Protection
  • Over Temperature Protection
  • Standard Remote Interfaces
Download Data Sheet
Print
Email

Specifications

RATED POWER OUTPUT

10 watts minimum

POWER OUTPUT @ 3dB COMPRESSION

Nominal

13 watts

Minimum

10 watts

POWER OUTPUT @ 1dB COMPRESSION

Nominal

11 watts

Minimum

9 watts

FLATNESS

2.0 dB typical

±3.0 dB maximum

FREQUENCY RESPONSE

4.0–10.6 GHz instantaneously

INPUT FOR RATED OUTPUT

1.0 milliwatt maximum, 0 dBm

GAIN (at maximum setting)

40 dB minimum

GAIN ADJUSTMENT (Continuous Range)

10 dB minimum

INPUT IMPEDANCE

50 ohms, VSWR 2.5:1 maximum

OUTPUT IMPEDANCE

50 ohms, nominal

MISMATCH TOLERANCE

100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance.

MODULATION CAPABILITY

Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal

HARMONIC DISTORTION

Minus 20 dBc maximum at 10 watts

THIRD ORDER INTERCEPT POINT

50 dBm typical

PRIMARY POWER

(selected automatically)

90-132, 180-264 VAC

50/60 Hz, single phase

 

CONNECTORS

RF

See Model Configurations

REMOTE INTERFACES

IEEE-488

24 pin female

RS-232

9 pin Subminiature D (female)

RS-232 (Fiber-optic)

Type ST

USB 2.0

Type B

Ethernet

RJ-45

SAFETY INTERLOCK

15 Pin Subminiature D

COOLING

Forced air (self contained fans)

Stay informed

To keep you in the loop of our latest news, register now for our email newsletter.