Amplifier Research 5700TP12G18 Pulse Amplifier 12 GHz – 18 GHz 5700W
Description
Amplifier Research 5700TP12G18 is a self contained, forced air cooled, broadband traveling wave tube (TWT) microwave amplifier system designed for pulse applications at low to moderate duty factors where instantaneous bandwidth and high gain are required. Reliable TWT subsystems provide a conservative 5700 watts minimum peak RF pulse power at the amplifier output connector. Stated power specifications are at the fundamental frequency.
The amplifier's front panel digital display shows forward and reflected average power output or forward and reflected peak power, plus extensive system status information accessed through a series of menus via soft keys. Status indicators include power on, warm-up, standby, operate, faults, excess average or peak reflected power warning and remote. Standard features include a built-in IEEE-488 (GPIB) interface, 0dBm input, TTL Gating, VSWR protection, gain control, RF output sample ports, auto sleep, plus monitoring of TWT helix current, cathode voltage, collector voltage, heater current, heater voltage, baseplate temperature and cabinet temperature. Modular design of the power supply and RF components allow for easy access and repair. Use of switching mode power supplies results in significant weight reduction.
The rated power is developed by efficiently power combining the outputs from two 3400 watts (nominal) pulse TWTs that are factory matched in gain and phase, resulting in an excellent combination of wide instantaneous bandwidth with improved harmonic levels.
Housed in a stylish contemporary cabinet, the amplifier provides readily available pulsed RF power for a variety of applications in Test and Measurement, (including EMC RF pulse susceptibility testing), Industrial and University Research and Development, and Service applications.
Features
- Broadband
- Forced air cooled
- Digital display
- Pulse Modulation
- IEEE-488 (GPIB) interface
- VSWR protection
- Gain control
- RF output Sample ports
- Auto sleep
Specifications
|
POWER (Fundamental), Peak Pulse, @ Output |
|
|
Nominal |
7,000 watts |
|
Minimum |
5,700 watts |
|
FLATNESS |
±10 dB maximum, ±5 dB at rated power |
|
FREQUENCY RESPONSE |
12 – 18 GHz |
|
INPUT FOR RATED OUTPUT |
1.0 milliwatt maximum |
|
GAIN (at maximum setting) |
67 dB minimum |
|
GAIN ADJUSTMENT (continuous range) |
35 dB minimum |
|
INPUT IMPEDANCE |
50 ohms, VSWR 2.5:1 maximum |
|
OUTPUT IMPEDANCE |
50 ohms, VSWR 2.5:1 typical |
|
MISMATCH TOLERANCE |
Output pulse width foldback protection at peak reflected power exceeding 3,000 watts. Will operate without damage or oscillation with any magnitude and phase of source and load impedance. May oscillate with unshielded open due to coupling to input. Should not be tested with connector off. |
|
PULSE CAPABILITY |
|
|
Pulse Width |
0.2 – 50 microseconds. |
|
Pulse Rate (PRF) |
100 kHz maximum |
|
Duty Cycle |
4% maximum. |
|
RF Rise and Fall |
35 ns max (10% to 90%). |
|
Delay |
300 ns maximum from pulse input to RF 90% |
|
Pulse Width Distortion |
±30 ns maximum (50% points of output pulse width compared to 50% points of input pulse width) |
|
Pulse Off Isolation |
80 dB minimum, 90 dB typical |
|
Pulse Input |
TTL level, 50 ohm nominal termination |
|
NOISE POWER DENSITY |
|
|
(pulse on) |
Minus 55 dBm/Hz maximum; Minus 80 dBm/Hz (typical) |
|
(pulse off) |
Minus 140 dBm/Hz (typical) |
|
HARMONIC DISTORTION |
Minus 15 dBc maximum |
|
PRIMARY POWER |
208V, US: 208 VAC 10%, 3 phase, delta (4 wire) 50/60 Hz, 5 KVA maximum |
|
CONNECTORS |
|
|
RF input |
Type N precision female on rear panel. See S1C option, if applicable. |
|
RF output |
Type WR-62 waveguide flange / coax on rear panel |
|
RF output forward and reflected sample ports |
Type N precision female on rear panel. See S1C option, if applicable. |
|
Pulse input |
Type BNC female on rear panel. See S1C option, if applicable. |
|
GPIB |
IEEE-488 female on rear panel. See S1C option, if applicable. |
|
Interlock |
DB-15 female on rear panel. See S1C option, if applicable. |
|
COOLING |
Forced air (self contained fans), air entry and exit in rear. |
|
SIZE (W x H x D) |
50.3 x 43 x 84 cm, 19.8 x 17 x 33 in |
|
WEIGHT (approximate) |
121 kg, 265 lbs |
